How To Install A White Rodgers Thermostat

The kitchen may be the heart of any habitation, only the thermostat is certainly what keeps everyone happy in that home. Whether you are upgrading to a smart home setup or just working with a new Air-conditioning or furnace, you lot can install a new thermometer with ease by following a few steps. You exercise not demand to be a professional person maintenance worker to execute this DIY-friendly project.

Assemble Your Tools

When executing whatever DIY projection, you e'er want to take your tools prepare and waiting so that you are non scrambling to discover something mid-project. To modify your thermostat, you demand:

A screwdriver set, or multi-bit screwdriver Masking tape A pen A digital camera or the camera on your telephone Drywall anchors (as needed)

Once you accept your tools, get together them on an easy-to-reach surface near your thermostat.

Plough Off the Power Source

Yous should never begin whatsoever electrical work in your home until you lot have turned off the power sources involved. Get to the breaker box in your dwelling and flip off the breakers that supply the furnace and the air-conditioning units. Make sure that yous test to ensure that the power is off, likewise. Adjust the temperature on the onetime thermometer by more than 10 degrees in both directions and encounter if either unit of measurement turns on. If not, you are golden and tin can proceed.

Remove the Sometime Faceplate

The next step is to remove the faceplate from the old thermostat. Virtually faceplates merely popular off. Yous can typically find a slot on the side of the unit or a latch that you can use to remove the faceplate. You should at present take access to the thermostat's wall plate and should run into the wiring and wall screws.

Label the Wires

This is mayhap the well-nigh critical step in the thermostat installation process, just like shooting fish in a barrel to execute. First, utilize your camera to accept a photograph of the wall plate and wiring. Yous can use this equally reference if there is any confusion downwardly the line. Your new thermostat may also provide wire labels. Use either your wire labels or the masking tape and pen to label each wire.

Remove the Wires and One-time Thermostat

Once you have labelled the wires, you tin can remove the wires from the former thermostat. You may need a screwdriver to loosen screws belongings the wires in identify. Some units may have clips holding the wires in identify. In those cases, all you lot need to do is open the clip and pull the wire out. Side by side, utilize your screwdriver to remove the screws holding the wall plate onto the wall.

Install Drywall Anchors

If your new thermostat has the same layout every bit your old 1, you can skip this stride. In some scenarios, the screws that hold your new wall plate in place may be in a different identify than on your old thermostat. If this is the case, install drywall anchors into your wall earlier screwing in the new wall plate. To exercise this, drill a hole the diameter of the anchors, then hammer the anchor into the wall until information technology is flush with the wall. Screw the new wall plate into the wall.

Wire in the New Thermostat

For your final step, you should install the wires into the new thermostat. You can reference your new user manual if there is any defoliation, but your labelled wires should stand for neatly with ports on the new thermostat. Place the confront plate onto the new thermostat, and so restore ability to the unit before testing information technology.